This battery pack System is applicable both for residential and commercial energy storage systems, which is assembled with an intelligent BMS for 51.2V100Ah lithium battery system. Each pack supports 16 packs in parallel to easily expand capacity. Do not mix in parallel battery packs of different brands or models.
Key Functions:
Battery voltage calculation: 16 battery voltage sampling test, deviation 20mV
Battery and ambient temperature detection: 4 battery temperature sensors, 1 ambient temperature sensor, 1 MOS temperature sensor, deviation 2.
Battery capacity and cycle times: complete a complete charging, discharging cycle to set the actual capacity. Monitor the remaining capacity of the battery with the capacity estimation accuracy within 5% deviation. In addition, the charging and discharging cycle time and the complete charging and discharging cycle time can be configured. Charging and static balance strategies can be flexibly set to effectively extend the service life.
Communication interface: PC or intelligent front-end can monitor battery data, control operation and set parameters through telemetry, remote signaling, remote adjustment, remote control and other commands. The communication protocol meets the requirements of YD/T 1363.3 and realizes cascade communication.
Historical data recording, saving and reading: when the battery is abnormal, record and save real-time battery status and alarm information. At present, up to 500 historical fault data can be stored.
Battery management system parameter settings: battery management system parameters, including cell battery over voltage/under voltage, battery total voltage over voltage/under voltage, charge and discharge over current, battery high/low temperature, battery capacity, working mode, charge and discharge limit current, can be set in the battery monitoring system.
Working mode: charging and discharging current limiting, constant voltage output, direct output and other working modes can be set in the monitoring system.
Multiple protection functions: hardware protection, battery protection, high and low temperature protection, output short circuit protection, etc.
Product Specification:
1. Configuration 1P16S
2. Nominal Voltage(V) 51.2V
3. Working Voltage(V) 42V~58.4V
4. Nominal Capacity(Ah) 100Ah
5. Rated energy(kWh) 5.12KWh
6. Rated charge/discharge Current(A) 100A @25 2
7. Maximum charging current 100A@25 2
8. Maximum discharge current 100A @25 2
9. Working Temperature: 0 40(Charge) - 20 40(Discharge)
10. Storage temperature -10~35 and humidity 25 2(Within three months of storage)
11. Dimension(LxWxH) (530) (442) (133)mm
12. Weight 45Kg 3kg
13. cycle life 4000 cycles @25 50A charge and discharge current 70% standard capacity 80% DOD
14. IP grade IP 21
15. Communication mode CAN&RS485
16. Altitude 0-3000m
17. Humidity range 5~80>#br###18. Compatible inverters: SRNE, Growatt, Goodwe, Victron, Deye, Luxpower etc.
What's in the box
1 x 5.12Kwh Lithium Ion Battery
1 x Hanging Ears
1 x 1.5m power cable
1 x Data sheet
Dimensions
No reviews found
